Mira Mode Instructions Manual page 26

6 mm Maximum
Depth
6 and 23 mm
Screw
(not supplied)
Pipework
*
70 mm
Clearance
*
Fixing type
*
(not supplied)
dependant
on wall structure
5. Fix the support bracket and shower
control in position using suitable fixings
(not supplied).
Note! The support bracket requires a
clearance depth of 70 mm, with a finished
wall thickness of 6 mm.
thicknesses in excess of 6 mm can be
accommodated, but clearance will be
required around the inlet and outlet
connections to allow insertion of pipe and
tightening of compression nuts.
6. Thoroughly flush the hot and cold
water supply pipes. The supplies must
be clean and free from debris before
connecting the shower control. Failure
to do so may result in product
malfunction.
7. Slide the compression nuts and olives
over the supply pipes.
8. Insert the hot and cold supply pipes fully
into the shower control and slide the olives
and compression nuts into place.
9. Use a suitable spanner to tighten the
compression nuts.
10. Continue the procedure as for solid and
dry-lined walls.
26
Wall