Mira Mode Instructions Manual page 25

26. Fit the shield assembly in place and hand
tighten it to secure the concealing plate
and foam seals in place.
Make sure that the "Mode" logo is
horizontal.
27. Fit the lever assembly and secure in
position with the grub screw.
Stud Partition, Shower Cubicle or Laminated Panel Walls
The built-in shower control is supplied with a support bracket that can be used to install
the shower control into the front face of a stud partition wall structure or the rear face
of a shower cubicle or laminated panel. The front face installation of the support bracket
is only practical where plaster or tiles can conceal flanges of the bracket. Installers may
wish to consider other options such as fabricating rear supports using wooden noggins,
however, these methods of fixing are beyond the scope of this guide.
Front Face Installation
1. Decide on a suitable position for mixer
where all users can operate.
2. Determine the route for the incoming hot
and cold supply pipework.
3. Determine the route for the outlet
pipework.
4. Cut a 124 mm diameter hole in the panel
and mark the fixing holes for the support
bracket at 45°.
Concealing Plate
Shield Assembly
124 mm
Diameter
25
Lever Assembly
Support
Bracket
Front Face