Mira Mode Instructions Manual page 19

10. Locate the shower control on to the
supply pipes and hold it in position.
11. Use a suitable spanner to tighten the
nuts and pull the shower control onto
the backplate. Protect the chromium
plated surfaces with a cloth. Use the
2.5 mm A/F hexagon wrench
(supplied) to tighten the two grub screw
in the backplate. The grub screw will
hold the shower control in position.
12. With the shower control turned off. Turn
on the water supplies and check for
any leaks.
Reversing Outlet
To reverse outlet connector follow
instructions below.
1. Using a suitable tool, flick the plug
cap from the centre of sealing plug
to reveal keyway.
2. Insert a 1/2" hexagon key (not
supplied) into keyway and remove
sealing plug.
3. To remove outlet connector, insert
key and remove as 2.
4. When refitting ensure 'o' seal is
located in recess of sealing plug
and outlet connector.
Shower Control
2.5 mm A/F
Hexagon Wrench
19