Mira Mode Instructions Manual page 18

Dimension from
finished wall
surface
110 mm
Centres
Olive
5. Remove the plaster and brick/block to the
required depth to conceal the pipework.
Note! Depth must be sufficient to prevent
pipe concealing plates fouling on the
plumbing elbows.
6. Install the supply pipes. The pipes must
be at 110 mm centres and project the
following distances from the finished wall
surface:
18 mm if flow regulators are being fitted.
21 mm if no flow regulators are fitted.
7. Finish the surface of the wall as required.
8. Slide the pipe concealing plates with 'O'
seals fitted, nuts and olives over the hot
and cold supply pipes.
9. Thoroughly flush the hot and cold
water supply pipes. The supplies must
be clean and free from debris before
connecting the shower control. Failure
to do so may result in product
malfunction.
Concealing Plate
Nut
18