Mira Mode Instructions Manual page 21

Mira Mode B
Solid and Dry-lined Walls
The built-in shower control is supplied with a support bracket (fitted) that can be used
for installation into a solid or dry-lined wall structure. Installers may wish to consider
other options such as fabricating rear supports using wooden noggins, however, these
methods of fixing are beyond the scope of this guide.
1. Decide on a suitable position for mixer
where all users can operate.
2. Determine the route for the incoming
hot and cold supply pipework.
3. Determine the route for the outlet
pipework.
4. Mark an opening sufficient to
accommodate the shower control on
the surface of the wall (124 mm
diameter). A carbide tipped hole cutter
can be used to produce the hole.
5. Mark the route of the supply and outlet
pipes.
21
124 mm Diameter