Mira Mode Maxim Installation And User Manual

Digital mixing valve

Hide thumbs

Table Of Contents

Enlarged version

Your Product Guarantee

This product has been designed for domestic use only, it is not recommended for Commercial or

Healthcare use.

For Domestic installations, Kohler Mira guarantee this product against any defect in materials or

workmanship for a period of five years from the date of purchase (shower fittings for one year). Within

the guarantee period we will resolve defects in materials or workmanship, free of charge, by repairing

or replacing parts or product as we may choose.

This guarantee only applies in the United Kingdom and the Republic of Ireland.

Activating Your Guarantee

Registering your guarantee is quick and simple. To ensure your product is covered, please register

online www.mirashowers.co.uk/support/guarantee-registration.

What is Covered

This guarantee is in addition to your statutory rights and is subject to the following conditions

• The guarantee applies solely to the original installation under normal use and to the original purchaser

only. The product must be installed and maintained in accordance with the instructions given in this

guide.

• Servicing must only be undertaken by us or our appointed representative.

Note! If a service visit is required the product must be fully installed and connected to

services.

• Repair under this guarantee does not extend the original expiry date. The guarantee on any replacement

parts or product ends at the original expiry date.

• For shower fittings or consumable items we reserve the right to supply replacement parts only.

What is Not Covered

• Call out charges for non product faults (such as damage or performance issues arising from incorrect

installation, improper use, inappropriate cleaning, lack of maintenance, build up of limescale,

frost damage, chemical attack, where no fault has been found with the product.

• Water or electrical supply, waste and isolation issues.

• Compensation for loss of use of the product or consequential or indirect loss of any kind.

• Damage or defects caused if the product is repaired or modified by persons not authorised by us or

our appointed representative.

• Routine maintenance or replacement parts to repaired or modified by persons not authorised by

comply with the requirements of the TMV2 or repaired or modified by persons not authorised by

TMV3 healthcare schemes.

• Accidental or wilful damage.

• Products purchased ex-showroom display.

Any questions regarding your guarantee? Give us a call on 0800 001 4040.

Eire

T: 0800 001 4040

T: 01 531 9337

E: askus@mirashowers.com

E: customerserviceeire@mirashowers.com

www.mirashowers.co.uk

www.mirashowers.ie

Mira is a registered trade mark of Kohler Mira Limited.

The company reserves the right to alter product specifications without notice.

1366055-W2-A

Installation and User Guide

Please leave these instructions with the user

Mira Mode Maxim

Digital Mixing Valve

Table of Contents

Need help?

Do you have a question about the Mode Maxim and is the answer not in the manual?

Questions and answers

Summary of Contents for Mira Mode Maxim

Page 1 Healthcare use. Mira Mode Maxim For Domestic installations, Kohler Mira guarantee this product against any defect in materials or workmanship for a period of five years from the date of purchase (shower fittings for one year). Within Digital Mixing Valve the guarantee period we will resolve defects in materials or workmanship, free of charge, by repairing or replacing parts or product as we may choose.
Page 2: Table Of Contents
Thank you for purchasing a Mira Mode Maxim. To enjoy the full potential of your new product, please take time to read this guide thoroughly, having done so, keep it handy for future reference. For step-by-step installation videos, datasheets or spares information, please visit the Mira Showers website.
Page 3: Important Safety Information
Off Remote Button in areas with high humidity and temperature (i.e. steam rooms and saunas). Products manufactured by Kohler Mira Ltd. are designed to be safe, provided that they are installed, used and maintained in good working order, in accordance with our instructions...
Page 4: Guarantee
5 backflow risk. Guarantee 1 x Component Pack The Mira Mode Maxim has been designed for domestic use only, it is not recommended for Commercial or Healthcare use. For domestic installations, Kohler Mira Ltd., guarantee the 1 x Backplate Mira Mode Maxim against any defect in materials or workmanship for a period of five years from the date of purchase (shower fittings for one year).
Page 5 Ceiling Fed Shower Fittings Rear Fed Shower Fittings 1 x Plastic Pipe 1 x Ceiling Plate 1 x Cover Cap 2 x Spacers 1 x Screw 1 x Handset 1 x Handset 1 x Hose 2 x Rubber Washers 1 x Elbow 1 x Extension 1 x Slide Bar Assembly...
Page 6 Ceiling Fed Deluge Head Rear Fed Deluge Head 1 x Concealing Shroud 1 x Concealing Plate 1 x Elbow 1 x Shower Arm 1 x Ceiling Mount Plate 1 x Deluge Head Assembly 2 x Wall Plugs 1 x Deluge Head 2 x Fixing Screws 1 x Rain Core 1 x Brazed Pipe...
Page 7: Specifications
Minimum Maintained Pressure 1 kPa (0.01 bar) 0.01m head mounting. The Mira Mode Maxim is in compliance with the essential requirements of the RED directive 2014/53/EU. A copy of the declaration of conformity may be obtained by visiting Supply Pressure Differential Nominally Equal www.mirashowers.co.uk/for-the-expert/resources/product-approvals.
Page 8: General Installation Notes
4. Gravity Fed Showers Caution! Risk of product damage. Do not fit the Mira Digital Mixing - High Pressure/ Combi Valve with Gravity Fed Systems. The shower control must be fed from a cold water storage cistern and a hot water cylinder providing nominally equal pressures.
Page 9: Installation Digital Mixing Valve
A Hot inlet flow regulator may need to be used to ensure that the Digital Mixing Valve can deliver a full range of water temperatures. Note: The Mira Dual outlet Digital Mixing Valves do not have a factory fitted hot inlet flow regulator. These are supplied in the component pack. The table indicates which flow...
Page 10: Controller
3 AMP double pole switched fused spur providing a minimum 3mm contact Digital Mixing Valve separation gap in each pole. Mira Mode Maxim Ceiling Fed shower fittings - Rear Fed options are available The use of supply-line or zone strainers will reduce the need to remove debris at the Deluge showerhead Digital Mixer Valve.
Page 11 Valve Installation Orientation Wiring to Fused Spur Box. The Digital Mixing Valve (which contains the thermostatic mixing valve)may only be orientated Make sure that the fused in the positions shown below. Failure to do so will compromise the ability of the unit to fail-safe spur is easily accessible.
Page 12 Installation: Controller Fit the backplate to the wall in the orientation shown using the fixing screws (supplied). Tighten by hand, do not over tighten. Position the installation template (supplied) at the position on the wall where you intend to install the Controller. Make sure that the template is level and mark the positions of the fixing holes on the wall.
Page 13: On/Off Remote Button
Installation: On/Off Remote Button Connect the cable to the back of the On/Off Remote Button and push the rubber grommet into place. The alignment of the On/Off Remote Button cannot be adjusted when it is fitted. Decide on a suitable location for the ON/OFF button. Mark the centre position and draw a vertical line using a spirit level to assist in the alignment of the ON/OFF button.
Page 14: Shower Fittings
Installation: Shower Fittings Drill the fixing holes in the wall. Fit the wall plugs and the slide bar supports and install the slide bar assembly to the wall. Important! If supplied slide bar spacers are required, centre distance for ceiling Use of Flow Regulators hole will increase to 75mm from wall.
Page 15 Install the screws top and bottom to Install the falling supply tube. Note: When shortening pipework for use with any push-fit fitting, follow secure the slide bar in position. manufacturer’s guidelines for finishing and cleaning the pipe. Note: The falling supply tube may need to be shortened, use a hacksaw to shorten tube.
Page 16 Installation: Ceiling Fed Deluge Head Note: Make sure that the deluge head Secure the brass pipe to the ceiling is not installed over the handshower. mount plate with the olive and 1/2” BSP nut. Offer the ceiling-fed arm to the brass Fix Deluge Head to the ceiling at a convenient height for all the family.
Page 17 Installation: Rear Fed Shower Fittings Connect the elbow (supplied) onto the Connect the shower control outlet end of the brass pipe. Push all parts pipework to the elbow. Fit an isolating together fully and lock elbow onto pipe valve between the shower control Suitable for solid, dry-lined, stud partition, shower cubicle or laminated panel walls.
Page 18 Mark the positions for the fixing holes Drill the fixing holes, fit the wall plugs Temporarily hold the top support in Drill the fixing hole for the top support and for the RAC back plate. and secure the backplate to the wall position.
Page 19 Installation: Rear Fed Deluge Head Carefully remove the slide bar Secure the assembly in position with assembly and tighten the screw the screws. The top securing screw on the back of the top bracket to tightens clockwise, the bottom one Fix at convenient height for all users.
Page 20: Commissioning
Commissioning Carefully fit the backplate over the F i t t h e c o n c e a l i n g s h r o u d , t h e outlet pipe and secure with the fixing compression nut and the olive onto the screws (supplied).
Page 21: Set Up
Set Up: Mobile Phone Maximum Temperature Setting with the Controller You can set up your shower using your iPhone or Android Phone with the Mira App. Hold down the Deluge showerhead Button Download the Mira App via the appropriate application store onto your compatible device: (top half) for 10 Seconds approx.
Page 22: Fault Diagnosis
Fault Diagnosis You can then use the Mira App to control your Digital Mixing Valve remotely via the water droplet symbol and/or adjust your setting using the gear symbol. Warning! Never remotely operate or alter any of the Mira Mode Maxim shower Read the section “Important Information”...
Page 23 Symptoms Probable Cause Possible Remedy Symptoms Probable Cause Possible Remedy Low flow (cont.) Digital Mixing Valve box failure. Contact Customer Services. Showering temperature too cool Digital Mixing Valve box failure. Contact Customer Services. (cont). Flow stops during showering ‘Shower run time’ setting is No product fault, refer to ‘using enabled.
Page 24: Cleaning & Maintenance
These finishes should be cleaned with a mild washing up detergent Digital Mixing Valve box failure. Contact Customer Services. or soap solution, and then wiped dry using a soft cloth. Unable to download the Mira Mode Out of date mobile phone operating Update mobile phone to the latest Showering App.
Page 25 Replace/Clean the Check Valves/Filters Cleaning the CloudCore™ spray plate Insert the spray plate removal tool into Read the section “Important Information” first. the corresponding feature in the core Before replacing any parts ensure that the underlying cause of the malfunction has been sprayplate.
Page 26 Notes:...

Mira Mode Maxim Installation And User Manual

Table of Contents

Need help?

Questions and answers

Related Manuals for Mira Mode Maxim

Summary of Contents for Mira Mode Maxim

Table of Contents