Removing And Replacing The Chassis Cover - Cisco 5580-40 - ASA Firewall Edition Hardware Installation Manual

Maintenance and Upgrade Procedures
This chapter describes maintenance and upgrade procedures. This chapter includes the following
sections:
•
•
•
•
•
•
•
The BIOS on the ASA chassis is specific to the ASA and must only be upgraded under instructions from
Caution
Cisco with BIOS files obtained from the Cisco website. Installing a non-Cisco or third-party BIOS on
the ASA voids the warranty.

Removing and Replacing the Chassis Cover

This section describes how to remove and replace the chassis cover from the ASA. This section includes
the following topics:
•
•
Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord.
Warning
Statement 1
Warning This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 120 VAC, 20 A U.S. (240 VAC, 16-20 A International).
Statement 1005
OL-12920-01
Removing and Replacing the Chassis Cover, page 4-1
Accessing the Diagnostic Panel, page 4-4
Removing and Installing the Interface Cards, page 4-4
Removing and Installing the Power Supply, page 4-6
Removing and Installing Fans, page 4-10
Upgrading the ASA 5580-20 to an ASA 5580-40, page 4-13
Troubleshooting Loose Connections, page 4-24
Removing the Chassis Cover, page 4-2
Replacing the Chassis Cover, page 4-4
Cisco ASA 5580 Series Adaptive Security Appliance Hardware Installation Guide
4
C H A P T E R
4-1