Table of Contents
Advertisement
7.
TAKING CARE OF
YOUR ALADIN H
7.1
Technical information
Operating altitude:
With decompression – sea level to
approximately 4000m/13300ft.
Without decompression (gauge mode) –
at any altitude.
Max operating depth:
120m/394ft; resolution is 0.1m until 99.9m
and 1m at depth deeper than 100m.
Resolution in ft is always 1ft. Accuracy is
within 2% ±0.3m/1ft.
Decompression calculation range:
0.8m to 120m/3ft to 394ft
Maximum environment pressure:
13bar/189psi
Maximum tank pressure
300bar/4350psi
Clock:
Quartz; time, date, dive time display up
to 199 minutes
Oxygen concentration:
Adjustable between 21% and 100%.
Operating temperature:
-10C to +50C/14F to 122F
Power supply:
CR2450 lithium battery
Life of the battery:
Estimated 2 years or 300 dives,
whichever comes first. Actual battery
life depends on the number of dives
per year, the length of each dive, the
water temperature and the usage of the
backlight.
7.2
Maintenance
The depth accuracy of your Aladin H
should be verified every 2 years and can be
done by an authorized SCUBAPRO dealer.
Aside from that, the Aladin H is virtually
maintenance-free. All you need to do is
rinse it carefully with fresh water after each
dive and change the battery when needed.
To avoid possible problems with your Aladin
58
H, the following recommendations will help
ensure years of trouble-free service:
• Avoid dropping or jarring your Aladin H.
• Do not expose your Aladin H to intense,
direct sunlight.
• Do not store your Aladin H in a sealed
container; always ensure that there is
ample ventilation.
• If there are problems with the water
contacts, use soapy water to clean
your Aladin H and dry it thoroughly. Do
not use silicone grease on the water
contacts!
• Do not clean your Aladin H with liquids
containing solvents.
• Check the battery capacity before each
dive.
• If the battery warning appears, replace
the battery.
• If any error message appears on
the display, take your Aladin H to an
authorized SCUBAPRO dealer.
7.2.1
Replacing the battery
(Use only the original SCUBAPRO battery
kit with O-ring.)
The change must be made with particular
care in order to prevent water from seeping
inside. The warranty does not cover
damage due to the improper replacement
of the battery.
WARNING
Never touch the metal surface of the battery
with bare fingers. The 2 battery poles must
never be short-circuited.
WARNING
• A leaking battery cap may lead to the
destruction of your Aladin H by water
seeping in, causing your Aladin H to switch
off without prior notice.
• Always open the battery compartment in a
dry and clean environment.
• Only open the battery compartment to
replace the battery.
ALADIN H USER MANUAL
Advertisement
Table of Contents
