Uwatec Aladin H User Manual page 50

Setting the MB Level
1. Confirm that you wish to change the MB
level setting with a press-and-hold of
the right button.
The value L0..L5 starts to flash.
2. Change the MB level by pressing the left
or right button.
3. Confirm the selected MB level with a
press-and-hold of the right button.
Setting the safety stop duration
1. Confirm that you wish to change the
duration of the safety stop with a press-
and-hold of the right button.
The duration starts to flash.
2. Change the duration in increments of 1
minute by pressing the left or right button.
3. Confirm the selected duration with a
press-and-hold of the right button.
Setting PDIS
50
PDIS (Profile Dependent Intermediate
Stop)
1. Confirm that you wish to enable PDIS
with a press-and-hold of the right
button.
"On" or "Off" starts to flash. "On"
indicates that the PDIS timer will be
automatically activated during the dive,
"Off" indicates that PDIS will be inactive.
2. Switch between "On" and "Off" by
pressing the left or right button.
3. Confirm your choice with a press-and-
hold of the right button.
Selecting water type
Selecting the water type
1. Confirm that you wish to change the
selected water type with a press-and-
hold of the right button.
"On" or "Off" starts to flash. "On"
indicates salt water, "Off" indicates fresh
water.
2. Switch between "On" and "Off" by
pressing the left or right button.
3. Confirm the water type with a press-
and-hold of the right button.
F
NOTE: Water type has an effect on
displayed depth. Roughly, 1bar/14.5psi
water pressure
10m/33ft depth in salt water and
10.3m/34ft depth in fresh water.
corresponds to
ALADIN H USER MANUAL