Taking Care Of Meridian; Technical Information; Maintenance - Uwatec Meridian Manual

Table of Contents

Advertisement

6.

taking Care oF Meridian

6.1 Technical information
operating altitude:
with decompression – sea level to approximately 4000m/13300ft
without decompression (GAUGE mode) – at any altitude
Max operating depth:
120m/394ft; resolution is 0.1m until 99.9m and 1m at depth deeper than 100m. Resolution 
in ft is always 1ft. Accuracy is within 2% ±0.2m/1ft.
decompression calculation range:
0.8m to 120m / 3ft to 394ft
Clock:
quartz clock, time, date, dive time display up to 999 minutes
oxygen concentration:
adjustable between 21% and 100%
operating temperature:
-10 ºC to +50 ºC / 14F to 122F
power supply:
CR2032 litium battery
Life of the battery:
2 years or 300 dives, which ever comes first. Actual battery life depends on the number of 
dives per year, the length of each dive, the water temperature and the usage of backlight.

6.2 Maintenance

The  depth  accuracy  should  be  verified  every  two  years,  by  an  authorized  SCUBAPRO 
dealer.  Aside  from  that,  Meridian  is  virtually  maintenance  free.  Meridian  is  manufactured 
from  highest  grades  of  stainless  steel.  Salt  water  and  substances  dissolved  in  it  may 
cause  corrosion,  surface  rust  or  build  an  organic  film  which  may  disturb  the  functions  of 
the Meridian. Therefore, it is necessary to rinse it carefully with fresh water after each dive 
and change the battery when needed. To avoid possible problems with your Meridian, the 
following recommendations will help assure years of trouble free service:
• avoid dropping or jarring your Meridian
• do not expose Meridian to intense, direct sunlight
• do not store Meridian in a sealed container, always ensure free ventilation
• If there are problems with the water contact, use soapy water to clean Meridian and dry
it thoroughly. Do not use silicone grease on the water contacts!
• Do not clean Meridian with liquids containing solvents.
• Check the battery capacity before each dive.
• If the battery warning appears, replace the battery.
• If any error message appears on the display, take Meridian back to an authorized
SCUBAPRO dealer.
SCUBAPRO MERIDIAN
6. taking care of Meridian
53

Advertisement

Table of Contents
loading

Table of Contents