Table of Contents
Advertisement
MB level
Further possible information about the dive:
Too fast ascent* (page 1).
STOP DECO Ignored decompression
stop* (page 1).
Diving in SOS mode (gauge mode) (page 4).
Altitude class (page 2).
MB level dive (L1-L5) (page 4).
STOP Ignored MB level stop* (page 1).
DESAT Desaturation was reset before the
dive (in USER menu) (page 1, 2).
Battery quality factor has been 3 bars or
less during the dive (page 1, 2, 3, 4, 5).
Diving in gauge mode (page 1, 2, 3, 4).
AVG Average depth (gauge mode) (page 4).
No-dive warning after the dive (page 1).
Page 5: gas 2 mix
*Alarms during the dive.
Pushing the right button gets you back
to the dive list (first level screen within
logbook). From here you can advance to
the next dive of interest by pushing the
right button, and then a press-and-hold
of the right button lets you retrieve more
information about that dive, etc.
4.3.2.5
Statistical information (HISTORY)
The history page is located between the last
and first log in the round-robin list of dives.
Deepest dive
ALADIN H USER MANUAL
Surface interval
Deco gas mix
Number of dives
Longest dive
Leaving the logbook
By pushing-and-holding the left button you
can exit the logbook. The logbook will also
close automatically after 3 minutes without
operation.
5.
SETTINGS
5.1
Altitude adjustment
The altitude adjustment does not affect
altitude class or calculations. To adjust the
altitude indicator to your current altitude:
1. Starting from the time of day display,
push the left or right button to get you
to the altitude screen.
2. Confirm that you wish to change the
displayed altitude with a press-and-hold of
the right button. The altitude starts to flash.
3. Change the altitude in increments of
10m/50ft by pushing either the left or
right button.
4. Confirm the selected altitude with a
press-and-hold of the right button.
45
Advertisement
Table of Contents
