Table of Contents
Advertisement
EN
14
Safety instructions
Working posture: Be sure you are well balanced with sure footing while working.
Exercise extreme caution when changing direction on slopes.
Attention! Exercise extreme caution when walking backwards. You could stumble!
Do not use the verticutter in the rain or in humid or wet conditions.
Do not operate the verticutter near pool or garden lake edges.
Please abide by all local restrictions regarding the noise level.
Work Interruption
Attention! Never leave the electric verticutter unattended in the working area.
If you stop working, store the equipment at a safe place. Remove the plugs from the mains!
If you interrupt work in order to move to another working area, always switch off the electric
verticutter during the move. Move the wear compensation lever to the transport position.
If you hit an obstacle during verticutting
Switch off the electric verticutter
Remove the obstacle.
Check the electric verticutter for any damage and have it repaired if necessary
Electrical Safety
Keep the extension cable off the cylinder of the verticutter!
Never use the verticutter in the rain.
Please observe the prescribed local rest periods.
It is necessary to check regularly the power supply / extension cable for any signs of damage
or wear.
If the power supply / extension cable is damaged, immediately remove the mains plug.
The extension receptacle for extension cable must be water-resistant to protect against
spraying water or the connecting receptacles for extension cables must be made of rubber or
rubber-coated.
The extension cables must meet the requirements of DIN VDE 0620.
Only use approved extension cables with adequate cable cross-section. Consult your
electrician.
Connecting accessories must be used for extension cables.
For portable devices used outdoors, we recommend using 30 mA residual current devices. In
Switzerland, the use of residual current devices is mandatory.
FZV 4001 E
Advertisement
Table of Contents
