Pin Outs - FDS FD215CV-C-5 Installation And Operation Manual

DB9 Power/Control Connector:
Suggested source of supply for DB9 connectors, manufactured by Tyco/Amp:
Connector
Crimp Contacts P/N
Wire
Note. The USB interface board is set to USB1.0 mode in order to permit maximum flexibility in the
choice of components used for the cable and connectors that are used between the monitor and the
USB host or KVM switch. USB specifies maximum cable length for USB 1.0 and 2.1 devices as 16 feet,
5 inches. This maximum length can be used if 100 Ohm low capacitance shielded twisted pair cable is
used. Reduce length if the cable does not fully meet the USB specifications for best results.
© 2017 FDS Avionics Corp.
All Rights Reserved.
Document Number:
MAN – FD215CV-C-5
P/N M24308/2-281
M39029/63-368
20 gauge wire is recommended
DB9 Pinout & Female Mating Face Profile
Pin
Number
1
2
3
4
5
6
7
8
9
Description
USB VBUS (Red)
USB D- (Green)
USB D+ (White)
USB Ground (Black)
Switch Input
RS-485A Quad
RS-485B Quad
RS-485A Scaler
RS-485B Scaler
TECHNICAL SUPPORT
470-239-7421 or FDSAvioncis.com
Revision Date:
Rev:
01/10/2017
B
Page 11 of 25