Table of Contents
Advertisement
Chapter 6
in the format text (6-28 characters). # an0ther$ecretpw
Confirm the wrapping password # an0ther$ecretpw
...
Sample: Replacing a Redundant Peer
Acopia Switch Startup
This Acopia switch does not currently have critical system
information programmed.
for this information.
the out-of-band management interface when you finish.
To restart the configuration program, enter 'r' at any prompt.
Acknowledge acceptance of the following terms and conditions
by entering 'yes' at the next question.
1. Press <Enter> to continue. # <Enter>
...
2. Enter 'yes' to accept these terms and conditions
in the format 'yes' or 'no'. # yes
The switch's management port requires an IP address and mask.
3. Enter the management port IP address
in the format nnn.nnn.nnn.nnn or 'none'. # 10.1.23.12
4. Enter the management port subnet mask
in the format nnn.nnn.nnn.nnn.(default=255.0.0.0) # 255.255.255.0
The switch's management port requires a gateway IP address.
5. Enter the gateway IP address for the management interface
in the format nnn.nnn.nnn.nnn or 'none'. # 10.1.23.1
A switch replacement requires additional configuration questions.
6. Are you doing a switch replacement?
in the format 'yes' or 'no'.(default=no) # yes
The switch's internal subnet requires an IP address and mask.
7. Enter the switch's private IP address
in the format nnn.nnn.nnn.nnn.(default=169.254.52.0) # 169.254.94.0
8. Enter the switch's private subnet mask
in the format nnn.nnn.nnn.nnn.(default=255.255.255.0) # <Enter>
The private subnet VLAN is used externally for redundancy traffic.
Be sure this value does not conflict with existing VLAN IDs.
9. Enter the chassis's private subnet VLAN
in the format integer [1-4095].(default=1002) # <Enter>
The private subnet metalog VLAN is used for storing file-change
logs on battery-backed NVRAM, possibly on a redundant peer.
Be sure this value does not conflict with existing VLAN IDs.
10. Enter the chassis's private subnet metalog VLAN
6 - 10
This sample script uses the private subnet, the UUID, and the master key to
replace a failed peer.
The following wizard prompts you
You can connect to the switch through
This next question invokes the questions for switch replacement:
Advertisement
Table of Contents
