Table of Contents
Advertisement
Chapter 6
; System UUID 876616f6-79ac-11d8-946f-958fcb4e6e35
; ip private vlan internal 1002 metalog 1003 subnet 169.254.94.0 255.255.255.0
;
config
logging level all info
exit
...
bstnA6k# show ron
Switch Name
Status
------------------------------------------------------------------------------
bstnA6k
ONLINE
provA5c
ONLINE
prtlndA1k
OFFLINE
bstnA6k# ...
Applying the UUID
...
The UUID should only be entered if this chassis is replacing a failed chassis
and the entered UUID should match the UUID of the failed chassis.
11. Enter the chassis's UUID
in the format
xxxxxxxx-xxxx-xxxx-xxxx-xxxxxxxxxxxx.(default=6df0854c-6af4-11d8-954a-f844c83bc5f3) #
876616f6-79ac-11d8-946f-958fcb4e6e35
...
6 - 8
If the failed switch was a member of a Resilient-Overlay Network (RON),
you can alternatively use
shows the UUID even if the chassis is no longer online. For example, the
following command (run on another switch in the RON) shows the UUID
for a failed chassis, "prtlndA1k." Again, the UUID is highlighted in bold
text:
HA Peer Switch
UUID
(None)
d9bdece8-9866-11d8-91e3-f48e42637d58
(None)
db922942-876f-11d8-9110-8dtu78fc8329
prtlndA1kB
876616f6-79ac-11d8-946f-958fcb4e6e35
The initial-boot script has a prompt for the UUID (shown in the example
above). This is where you enter the UUID of the replaced switch. For
example,
Important
No two running chassis should ever share the same UUID. Only enter the
UUID in a switch-replacement scenario.
show ron
from any other RON member. This
Management Addr
0 days, 02:02:47
0 days, 02:01:04
10.1.38.19
0 days, 00:30:53
10.1.23.11
Uptime
10.1.1.7
Advertisement
Table of Contents
