Power Supply Disconnection Warning; Battery Handling Warning - Acopia ARX 1000 Hardware Installation Manual

Power Supply Disconnection Warning

Battery Handling Warning

International Power-Cord Requirements
ARX®1000 Hardware Installation Guide
WARNING
Before working on a chassis or working near power supplies, unplug the
power cord on AC units.
ATTENTION
Avant de travailler sur un châssis ou à proximité d'une alimentation
électrique, débrancher lecordon d'alimentation des unités en courant.
WARNING
There is the danger of explosion if the battery is replaced incorrectly.
Replace the battery only with the same or equivalent type recommended by
the manufacturer. Dispose of used batteries according to the manufacturer's
instructions.
ATTENTION
Danger d'explosion si la pile n'est pas remplacée correctement. Ne la
remplacer que par une pile de type semblable ou équivalent, recommandée
par le fabricant. Jeter les piles usagées conformément aux instructions du
fabricant.
International Cords should have the following characteristics-
• maximum length: 4.5 m/15 feet
• Female End: IEC-320-C13
• Capacity: 10A/250V
• Nominal Conductor size(s): 1.0mm2
• Approvals: Appropriate to the country in which it is to be used.
Safety and Regulatory Notices
1 - 9