Ethernet-Port Link Status Leds; Hard-Drive (Hd) Led - Acopia ARX 1000 Hardware Installation Manual

Chapter 7
ALERT STATUS
(Off) Green
Red Green (Blinking)
(Off) Yellow (Blinking)
(Off) Yellow
Red Yellow
(Off) (Off)
Table 7.1 Operational States and LED Patterns

Ethernet-Port Link Status LEDs

Hard-Drive (HD) LED

7 - 6
During various module operations, LEDs display Green, Yellow, or Red
with intermittent blinking patterns, depending on the state. When blinking,
LEDs blink ON for a half second and OFF for a half second.
Table 7.1 describes the LED colors and blinking patterns that occur during
various operational states, such as booting, diagnostics, and so on.
State
Online
Failed or powering down
Powering up and running all POST tests.
Online Partial: at least one processor is online, at least one is not online yet.
If the offline processor does not come up in 5 minutes, this changes to Failed
Partial.
Failed Partial: at least one processor is online, but at least one other processor
failed.
Power Failure
The Ethernet ports on the ARX®1000, the MGMT port and the client/server
ports, each have two LEDs in their upper corners:
• Upper left – Activity LED: blinking yellow indicates packet traffic.
• Upper right – Link-status LED: steady green indicates that the port is
enabled and a link is established.
The hard drive (HD) LED is not supported.