Led Status Indicators; Status Leds - Acopia ARX 1000 Hardware Installation Manual

LED Status Indicators

Status LEDs

ARX®1000 Hardware Installation Guide
This section describes the ARX®1000's status LEDs, including:
• system Alert and module Status LEDs (see Figure 7.3)
• hard-drive LED and NVR-battery-backup LEDs (also shown in
Figure 7.3)
• Ethernet management port and user port LEDs (see Figure 7.4 on
page 7-5)
Figure 7.3 ARX®1000 System LEDs
system Alert (red
if hardware fails)
module Status
(green = 'all OK',
yellow = 'at least
one failed')
Hard Disk
activity (not
supported)
Figure 7.4 ARX®1000 Port LEDs
each port has one Activity LED (yellow) and one Link LED (green)
The ARX®1000 front panel provides the following LED status indicators:
• ALERT — Illuminates Red to indicate an operational failure
• STATUS — Illuminates Green or Yellow based on the system's current
operational state
LED Status Indicators
yellow when NVR
powered by backup
battery
7 - 5