Safety Instructions; Tools And Equipment - Acopia ARX 1000 Hardware Installation Manual

Safety Instructions

Tools and Equipment

ARX®1000 Hardware Installation Guide
Observe the following safety guidelines to avoid personal injury or damage
to equipment when installing or operating the switch:
DANGER
Never assume that power is disconnected from a circuit; always check.
Before installing the switch, locate the power ON/OFF toggle on the back of
the switch and make sure it is set to OFF.
Disconnect any power or external cables before moving the switch.
Disconnect the power cord before servicing the unit to avoid electric shock.
You need the following equipment for unpacking, rack-mounting, and
installing the switch:
• Utility knife (optional, for the packaging)
• Phillips screwdriver for #10 screws
• A laptop or PC to use as a serial console
• Customer-supplied standard 19-inch EIA rack
Note
Older revisions of the rails require a 3/8-inch nut driver in addition to the
equipment above.
Safety Instructions
5 - 3