To Set Redial Interval; Setting Dial Tone Detection - HP Analog Fax Accessory 300 Fax Manual

3
4
5

To set redial interval

The redial interval setting selects the number of minutes between
retries if the number dialed is busy or not answering.
1
2
3
4
5
You may observe a redial message on the control panel when both the
Note
Redial-on-Busy and Redial-on-No-Answer settings are set to off.
This occurs when the fax accessory dials a number, establishes a
connection, and then loses the connection. As a result of this error
condition, the fax accessory performs two automatic redial attempts
regardless of the redial settings (the first one at 26,400 bps and, if that
fails, a second one at 14,400 bps). During this redial operation, the fax
accessory displays a message on the control panel that indicates that
a redial is in progress.

Setting dial tone detection

The detect dial tone setting determines whether the fax checks for a
dial tone before sending a fax.
To enable or disable dial tone detection, perform the following steps.
1
2
3
4
52 Chapter 3 Configuration
Scroll down and touch FAX SEND.
Scroll down and touch REDIAL ON NO ANSWER to display the
setting screen.
Use the up and down arrows to select the number (default=0),
and then touch OK.
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX SEND.
Scroll down and touch REDIAL INTERVAL to display the setting
screen.
Use the up and down arrows to select the number (1 through
5 minutes; default=5), and then touch OK.
On the control panel, press the Menu button to display the
main menu.
Touch FAX to display the fax menu.
Scroll down and touch FAX SEND.
Scroll down and touch DETECT DIAL TONE to display the detect
dial tone settings.
ENWW