Parameter Setting By Means Of Gsd File - Siemens ASM 456 Operating Instructions Manual

5.2

Parameter setting by means of GSD file

In addition to the PROFIBUS-relevant control parameters, several MOBY-relevant control
parameters are also defined for the ASM 456 in the GSD file. The relevant parameters are
set using the "Object properties" of the slave in HW Config or the TIA Portal. The parameters
are described in the function manual "FB 45" or "Ident profile and Ident blocks".
The table below shows the possible setting options. Note that the setting options shown in
the table depend on the connected reader and selected user mode.
Table 5- 1
User Mode
MOBY Mode
Transmission speed
Diagnostics messages (see
section "Diagnostics
(Page 43)")
Suppression of Error LED
not permitted with MOBY D with write/read device D11S/D12S
1)
ASM 456 interface module
Operating Instructions, 07/2015, J31069-D0162-U001-A6-7618
Setting the relevant parameters
Parameter name
5.2 Parameter setting by means of GSD file
Value
Ident profile/RFID standard profile
FB 45 / FC 45
FB 55 / FC 55
FC 56
RF200/RF300/RF600; MV4x0; MOBY
U/D
RF680R/RF685R
MOBY I/E normal addressing
RF300 file handler
MOBY U file handler
MOBY I file handler
19.2 kBd
57.6 kBd
115.2 kBd
none
Hard errors
Hard/soft error low priority
Hard/soft error high priority
none
Channel 1
Channel 2
Parameterization
Note
Default
-
-
-
Default
-
-
-
only with FC 56 (multitag) or
RFID standard profile
-
-
1)
Default
1)
Standard diagnostics only
Hardware-related messages
only
All messages
All messages high-priority
Default
Suppression of startup flash-
ing on channel 1 if no reader
is connected there.
Suppression of startup flash-
ing on channel 2 if no reader
is connected there.
35