Siemens ASM 456 Operating Instructions Manual page 19

Tools required for M12, 7/8" connection block
● Socket wrench 14 mm
● Screwdriver 2.5 mm
Setting PROFIBUS DP addresses on connection block M12, 7/8"
Permitted PROFIBUS DP addresses are 1 to 99.
1. Remove the two seal caps from the rotary switches (if necessary, use a 14 mm socket
wrench).
2. Set the required PROFIBUS address on the rotary switches using a screwdriver.
– Lower rotary switch: 1st position
– Upper rotary switch: 10th position
3. Screw the two seal caps back onto the rotary switches
(torque: 0.5 to 0.8 Nm.)
Figure 4-2
ASM 456 interface module
Operating Instructions, 07/2015, J31069-D0162-U001-A6-7618
Setting PROFIBUS addresses on connection block M12, 7/8"
4.1 Setting the PROFIBUS address
Connection
19