Table of Contents
Advertisement
Closing the blade server cover
Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed. Do not attempt to override this protection.
The following illustration shows how to close the blade server cover.
Figure 21. Closing the blade server cover
Complete the following steps to close the blade server cover:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Close the inner cover. It clicks into place when it is closed, see Figure 21, step
3. If you removed the blade bezel assembly, replace it now. See "Installing the
4. If you removed the second power board, replace it now, see Figure 21, step 2.
5. If you disconnected any PCI-Express cables reconnect them now. See the
6. Lower the cover so that the slots at the rear slide down onto the pins at the rear
42
BladeCenter QS20 Type 0200: Installation and User's Guide
1. Close inner cover
3. Close outer cover
page 21.
1.
blade server bezel assembly" on page 40 for instructions, and Figure 21, step 2.
documentation that comes with the InfiniBand option for detailed installation
instructions.
of the blade server, as shown in the illustration. Before closing the cover, make
sure that all components are installed and seated correctly and that you have
not left loose tools or parts inside the blade server.
2. Replace second power board and front bezel
Second power board
Front bezel
Advertisement
Table of Contents
