Table of Contents
Advertisement
Attention:
the number of the bay that contains the blade server before you remove it. Then,
reinstall the blade server in the same bay from which it was removed. Reinstalling a
blade server into a different bay than the one from which it was removed could
have unintended consequences, such as incorrectly reconfiguring the blade server.
Some blade server configuration information and update options are established
according to bay number. If you reinstall the blade server into a different bay, you
might have to reconfigure the blade server.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Complete the following steps to install a blade server into the BladeCenter unit:
18
BladeCenter QS20 Type 0200: Installation and User's Guide
If you plan to remove a blade server and reinstall it, be sure to note
1. Read the safety information beginning on page v and "Installation guidelines"
on page 21.
2. If you have not done so already, install any options needed, such as disk
drives or memory, in the blade server.
3. Select the bay for the blade server.
4. If the bay that you selected contains filler blades, remove the filler blades. For
future use, store the filler blades in a static-protective environment.
5. Make sure that the release levers on the blade server are in the open position
(perpendicular to the blade server).
6. Slide the blade server into the bay until it stops. The spring-loaded doors
further back in the bay that cover the bay opening move out of the way as you
insert the blade server.
7. Push the release levers on the front of the blade server to the closed position.
8. (Optional) A set of user labels comes with the blade server. Write identifying
information on one of the user labels for the blade server; then, place the label
on the BladeCenter unit bezel just below the blade server, as shown in
Figure 7 on page 19.
If you install a blade server in bay 13-14, place the label next to the product
name. Do not cover the label that contains the system information.
Advertisement
Table of Contents
