IBM BladeCenter QS20 Installation And User Manual page 42

1. Install the hard disk into the blade server
Figure 11. Installing the hard disk
Attention:
v Do not press on the top of the hard disk drive when installing it. Pressing the top
v IDE hard disk drives must be set to master.
Complete the following steps to install a 2.5-inch IDE hard disk drive:
10. If you have other options to install or remove, do so now; otherwise, go to
28
BladeCenter QS20 Type 0200: Installation and User's Guide
Cable connected to
PCI ATA Controller
PCI ATA Controller
IDE Drive
Cable connected to
hard disk
Tray
could damage the hard disk drive.
1. Read the safety information beginning on page v and "Installation guidelines"
on page 21.
2. If the blade server is operating, shut down the Linux operating system by
typing the shutdown -h now command. If the blade server was not turned off,
press the power-control button (behind the blade-server control-panel door) to
turn off the blade server. See "Blade server controls and LEDs" on page 11 for
more information about the location of the power-control button.
3. Remove the blade server from the BladeCenter unit. (See "Removing the
blade server from the BladeCenter unit" on page 23 for instructions.) Carefully
place the blade server on a flat, static-protective surface.
4. Open the blade server cover. See "Opening the blade server cover" on page
25 for instructions.
5. Place the tray from the option kit on the system board, aligning the tray with
the screws on the system board. Note the four screws that are under the four
screw holes in the tray. Set the tray aside and remove the four screws.
6. Replace the tray and secure the tray to the system board with screws from the
hardware kit.
7. Connect the cable to the PCI ATA controller at one end and the hard disk drive
at the other end.
8. Insert the PCI ATA controller card into the slot on the system board
9. Place the hard disk drive into the tray and, from the rear edge of the hard disk
drive, push it into the tray. The hard disk drive clicks into place.
"Completing the installation" on page 40.
2. Hard disk and PCI ATA controller installed on the
blade server system board
Cable connected to
PCI ATA controller
PCI ATA controller
Cable connected to
hard disk
Hard disk