Closing the blade server cover
Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed, or a SCSI storage expansion unit is installed. Do not
attempt to override this protection.
The following illustration shows how to close the blade server cover.
Complete the following steps to close the blade server cover:
1. Review the information in "Safety" beginning on page vii and "Installation
2. If you removed the blade bezel assembly, replace it now. See "Installing the
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear
4. Pivot the cover to the closed position as shown in the illustration, until it clicks
40
BladeCenter HS20 Type 8832: Installation and User's Guide
Cover
pins
guidelines" on page 19.
blade server bezel assembly" on page 39 for instructions.
of the blade server, as shown in the illustration. Before closing the cover, check
that all components are installed and seated correctly and that you have not left
loose tools or parts inside the blade server.
into place.