Table of Contents
Advertisement
What you need to install InfiniBand
Make sure you have a small flat screwdriver before you install your InfiniBand card.
Installing InfiniBand
To install an InfiniBand option, do the following:
30
BladeCenter QS20 Type 0200: Installation and User's Guide
Table 3. InfiniBand package contents (continued)
Description
1 x blade bezel
4 x screws
1 x gasket
1. Shut down the BladeCenter QS20.
2. Remove the BladeCenter QS20 from BladeCenter.
3. Open the top cover.
4. Unlatch the front bezel and partially remove it from the metal guides.
5. Unplug the control panel and serial cable connectors from the blade's board as
shown in Figure 12 on page 31.
What the item looks like
Advertisement
Table of Contents
