Table of Contents
Advertisement
Attach here
Figure 7. Where to attach user labels
Important: Do not place the label on the blade server or in any way block the
ventilation holes on the blade server.
9. If this is not the initial installation of this blade server in the BladeCenter unit,
continue with the next step.
If this is the initial installation of this blade server in the BladeCenter unit, you
must perform the following additional tasks:
a. Turn on the blade server by pressing the power-control button on the blade
server control panel. The power-on LED on the blade server changes from
the slowly-flashing state to a continuously lit (steady) state.
b. Install the operating system. Use the installation instructions that come with
the operating system. For more information, see Chapter 7, "Installing the
operating system," on page 51.
10. If you have already installed the operating system on the blade server, the
blade server is ready to use.
If you have not already done so, turn on the blade server by pressing the
power-control button on the blade server control panel. The power-on LED on
the blade server changes from the slowly-flashing state to a continuously lit
(steady) state.
11. If you have other blade servers to install, you can do so now.
Chapter 4. Installing the blade server in the BladeCenter unit
19
Advertisement
Table of Contents
