Table 10-2 System Commands For Ethernet - Keithley 2701 User Manual

Model 2701 User's Manual
Remote programming
System commands to select and configure Ethernet are listed in
NOTE
Table 10-2
SYSTem commands for Ethernet
Command
SYSTem
:COMMunicate
:SELect <name>
:ETHernet
:ADDRess <value>
:ADDRess?
:MASK <value>
:MASK?
:GATeway <value>
:GATeway?
:DHCP <b>
:DHCP?
:MAC?
Ethernet and RS-232 settings are not affected by *RST or SYSTem:PRESet. The
Ethernet settings set at the factory are shown in
Ethernet and RS-232 commands:
Select communications mode; ETHernet or SERial.
Ethernet:
Set IP address of 2701; "n.n.n.n".
Query IP address of 2701.
Sets the subnet mask; "n.n.n.n".
Query subnet mask.
Set the Ethernet gateway; "n.n.n.n".
Query the Ethernet gateway.
Enable or disable Dynamic Host Control Protocol (DHCP).
Query state of DHCP.
Returns MAC address of 2701; 6 hexadecimal values
separated by colons (00:60:1A:00:04:0B).
Remote Operations
Figure 10-7
Description
10-15
Table 10-2.
and Figure 10-8.