Saving Setup; Auto Scan; Scan Operation - Keithley 2701 User Manual
Ethernet-based dmm/data acquisition system
Hide thumbs
Also See for 2701:
- User manual (478 pages) ,
- Service manual (168 pages) ,
- Instruction manual (61 pages)
Table of Contents
Advertisement
Model 2701 User's Manual
Saving setup
Up to five instrument setups can be saved in memory using the SHIFT > SAVE menu
(SAV0, SAV1, SAV2, SAV3, or SAV4). A user-saved setup can also be used as the power-
on setup. A user-saved setup can be restored from the SHIFT > SETUP menu. Details on
user-setups are covered in
Auto scan
When auto scan is enabled, the scan operation is saved in memory. If power to the
Model 2701 is interrupted, the scan will resume when power is restored. With auto scan
enabled, the last scan setup becomes the power-on setup. It takes precedence over the
factory, *RST, or user-saved power-on setup.
Perform the following steps to set auto scan.
1.
2.
3.
4.
NOTE
Scan operation
A basic scan is controlled solely by the STEP and SCAN keys. When one of these keys is
pressed, the STEP or SCAN operation will be performed. For the manual/external trigger
scan, the TRIG key or triggers received from another instrument starts the STEP or SCAN
operation. For the monitor scan, a channel monitors readings. When a set reading limit is
reached, STEP or SCAN will start.
Section
While in the normal measurement state, press SHIFT and then SETUP.
Use the
and
keys to display the auto scan (AUTOSCAN) setting: N (no) or Y
(yes).
To change the setting, press
or
to change the setting.
Press ENTER to exit from the menu structure.
With auto scan enabled, DO NOT save the present setup as the power-on default
setup. If you do so, an interrupted scan will not resume.
If during the power-up sequence the Model 2701 detects a card ID change for
any slot, auto scan configuration will disable and an interrupted scan will not be
resumed. Error +517 occurs (cannot resume scan) to indicate that the scan has
been disabled. The instrument assumes the normal power-on setup.
The Model 7706 does not support auto scan. Trying to enable auto scan with a
Model 7706 card installed will cause error -221 (settings conflict).
1.
to place the cursor on the setting (N or Y) and press
Scanning
7-21
Advertisement
Table of Contents
