Taylor-Dunn B0-012-10 Operation, T Roubleshooting And Replacement Parts Manual page 105

REPLACE THE TIRE (PNEUMATIC)
NOTE; To replace the tire, the tire/wheel assembly must be removed from the vehicle. Refer to
the Tire/Wheel
Explosion Hazard. Fully deflate the tire before attempting to remove
the tire from the wheel. Do not over inflate the tire when seating the
bead. Failure to deflate the tire or over inflating the tire to seat the
bead may cause explosive failure of the tire resulting in severe bodily
injury or death.
Tire replacement should only be performed by personnel trained in tire replacement.
The tire replacement procedure will be unique to the type of replacement equipment being used. Refer to
the instructions provided with your equipment.
Always use a new valve stem when replacing a tire.
1. Remove the tire from the wheel.
2. Cut the old valve stem off of the wheel.
3. Remove the valve stem cap from the new valve stem.
4. Lubricate the valve stem with liquid soap.
5. Install a new valve stem using a valve stem tool.
NOTE: The valve stem tool is available at most auto repair shops.
6. Install the tire onto the wheel following the instructions provided with your tire replacement equipment.
7. Inflate the tire to the proper pressure and check for leaks.
8. Install the valve stem cap.
Maintenance, Service, and Repair
section for information on removing the tire/wheel assembly.
Replace
Tires and Wheels
Page 5