Universal Serial Bus Ports - DFI G4E620-N User Manual

2
Hardware Installation

2.5.5 Universal Serial Bus Ports

USB 2
USB 1
USB 4
USB 3
Four onboard USB ports (Black) are at locations CN5 and CN6.
J10 allows you to connect 2 additional USB ports. The additional
USB ports, which are mounted on a card-edge bracket, will be
provided as an option. If you wish to use the optional USB ports,
install the card-edge bracket to the system chassis then insert the
connector that is attached to the USB port cables to J10.
BIOS Setting
Enable or disable the onboard USB in the Integrated Peripherals
submenu of the BIOS. Refer to chapter 3 for more information.
If you are using a USB 2.0 device, you must enable the USB 2.0
function in the same submenu mentioned above.
Driver Installation
You may need to install the proper drivers in your operating system
to use the USB device. Refer to your operating system's manual
or documentation for more information.
If you are using USB 2.0 devices, install the "USB 2.0 Drivers".
Refer to chapter 4 for more information.
32
J10
10
2
9
1