Table of Contents
Advertisement
2
Hardware Installation
Adding a Second IDE Disk Drive
When using two IDE drives, one must be set as the master and
the other as the slave. Follow the instructions provided by the
drive manufacturer for setting the jumpers and/or switches on
the drives.
The system board suppor ts Enhanced IDE or ATA-2, ATA/33,
ATA/66 or ATA/100 hard drives. We recommend that you use hard
drives from the same manufacturer. In a few cases, drives from two
different manufacturers will not function properly when used together.
The problem lies in the hard drives, not the system board.
CompactFlash
CompactFlash
CompactFlash
drive connected to the IDE 2 connector is set to Slave mode.
BIOS Setting
Enable or disable the onboard primary or secondary IDE con-
troller in the Integrated Peripherals submenu ("OnChip IDE De-
vice" field) of the BIOS. Refer to chapter 3 for more information.
40
Note:
Refer to your disk drive user's manual for information about
selecting proper drive switch settings.
Important:
If you encountered problems while using an ATAPI CD-ROM
drive that is set in Master mode, please set the CD-ROM drive
to Slave mode. Some ATAPI CD-ROMs may not be recognized
and cannot be used if incorrectly set in Master mode.
TM
and IDE 2 share the same channel. Since
TM
on this board is always in Master mode, if a
TM
card is installed in the socket, make sure the
Advertisement
Table of Contents
