Universal Serial Bus Ports - DFI P4M266A-MLV User Manual

2.5.3 Universal Serial Bus Ports

USB 2
USB 1
1 0
2
1
The system board supports 4 USB 2.0/1.1 ports. Two onboard USB
ports (Black) are at location CN1 of the system board.
The J26 (USB 3-4) connector allows you to connect 2 additional
USB ports. The additional USB ports may be mounted on a card-
edge bracket. Install the card-edge bracket to the system chassis
then insert the cable connector to J26.
BIOS Setting
Configure the USB ports in the Integrated Peripherals submenu
("VIA OnChip PCI Device" field) of the BIOS. Refer to chapter 3 for
more information.
Driver Installation
You may need to install the proper drivers in your operating system
to use the USB device. Refer to your operating system's manual or
documentation for more information.
If you are using USB 2.0 devices, install the "VIA USB 2.0 Drivers".
Refer to chapter 4 for more information.
Hardware Installation
"
USB 3-4
"
9
2
31