Table of Contents
Advertisement
2.4.2 Jumper Settings for Selecting the CPU's Front Side
Bus
This jumper is used to select the front side bus of the CPU
installed on the system board. The default setting is Auto. The
system will run according to the front side bus of the CPU in-
stalled on the system board.
Important:
• If you are using a CPU whose frequency has been locked
by the manufacturer, overclocking will have no effect.
• Overclocking may result to the CPU's or system's instability
and are not guaranteed to provide better system
performance.
Hardware Installation
3
JP1
2
1
1-2 On: Auto
2-3 On:
(default)
100MHz
3
3
2
2
1
1
All Off:
133MHz
25
2
Advertisement
Table of Contents
