Table of Contents
Advertisement
Wake-On-USB Keyboard
The Wake-On-USB Keyboard function allows you to use a USB
keyboard to wake up a system from the S3 (STR - Suspend To
RAM) state. To use this function:
• Jumper Setting:
JP5, JP6 and/or JP7 must be set to "2-3 On: Enabled". Refer to
"Jumper Settings for Selecting the USB Power" in this chapter
for more information.
• BIOS Setting:
"USB KB Wake-Up From S3" in the Power Management Setup
submenu of the BIOS must be set to Enabled. Refer to chap-
ter 3 for more information.
Important:
• If you are using the Wake-On-USB Keyboard function for 2
USB ports, the 5VSB power source of your power supply
must support ≥ 1.5A.
• If you are using the Wake-On-USB Keyboard function for 3
or more USB ports, the 5VSB power source of your power
supply must support ≥ 2A.
Hardware Installation
2
33
Advertisement
Table of Contents
