Table of Contents
Advertisement
Wake Up On LAN
If you are using a LAN card that supports the remote wake up
function, set this field to Enabled. The will allow the network to
remotely wake up a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can wake up the sys-
tem only through an IRQ or DMA interrupt. Refer to "Wake-On-
LAN Connector" in chapter 2 for more information.
Resume By Alarm
Enabled When Enabled, you can set the date and time you
would like the Soft Power Down (Soft-Off) PC to
power-on in the "Date (of Month) Alarm" and "Time
(hh:mm:ss) Alarm" fields. However, if the system is
being accessed by incoming calls or the network
(Resume On Ring/LAN) prior to the date and time
set in these fields, the system will give priority to the
incoming calls or network.
Disabled Disables the automatic power-on function. (default)
Date (of Month) Alarm
0
The system will power-on everyday according to the
time set in the "Time (hh:mm:ss) Alarm" field.
1-31
Select a date you would like the system to power-
on. The system will power-on on the set date, and
time set in the "Time (hh:mm:ss) Alarm" field.
Time (hh:mm:ss) Alarm
This is used to set the time you would like the system to power-
on. If you want the system to power-on everyday as set in the
"Date (of Month) Alarm" field, the time set in this field must be
later than the time of the RTC set in the Standard CMOS Fea-
tures submenu.
Award BIOS Setup Utility
3
79
Advertisement
Table of Contents
