Table of Contents
Advertisement
2
Hardware Installation
Warning:
.
.
.
.
.
.
.
.
Electrostatic discharge (ESD) can damage your system board,
processor, disk drives, add-in boards, and other components. Perform
the upgrade instruction procedures described at an ESD workstation
only. If such a station is not available, you can provide some ESD
protection by wearing an antistatic wrist strap and attaching it to a
metal part of the system chassis. If a wrist strap is unavailable,
establish and maintain contact with the system chassis throughout
any procedures requiring ESD protection.
2.2 System Memory
The system board is equipped with two 184-pin DDR SDRAM
DIMM (Dual In-line Memory Module) sockets that support 2.5V
DDR SDRAM DIMM. Double Data Rate SDRAM (DDR SDRAM)
is a type of SDRAM that doubles the data rate through reading
and writing at both the rising and falling edge of each clock. This
effectively doubles the speed of operation therefore doubling the
speed of data transfer. Refer to chapter 1 (System Memory section)
for detailed specification of the memory supported by the system
board.
BIOS Setting
Configure the system memory in the Advanced Chipset Features
submenu of the BIOS.
16
DDR 1
DDR 2
Advertisement
Table of Contents
