Possible Faults; Technical Data - ATIKA HHS 710/56 Original Instructions Manual

Fault
Hedge trimmer does not work.
Hedge trimmer cuts
interruptions
Motor is running, knives do not
move
Knives get hot
Motor is humming, knives do not
move
Typ / Modell
Year of construction
Motor output P
1
Mains voltage / Mains frequency
No-load speed n
0
Length of knives
Cutting length
Cutting distance
Hand-arm vibration according to EN 60745
Front handle
Rear handle
Measuring uncertainty K
Measured sound power level L
Guaranteed sound power level L
Sound pressure level L
PA
Measuring uncertainty K
Teleskopstiel - Höhe min. ( Höhe max.) ca.
Gewicht (mit Teleskopstiel) ca.
Protection class

Possible faults

Possible cause
• No power
• Power failure
• Extension cable defect
• Safety fuse defect
• Motor or switch defect
with • Cable defect
• Internal failure
• Circuit closer/breaker defect
• Internal failure
• Knives are edgeless
• Knives are defect
• Missing lubrication => friction
• Knives are blocking

Technical Data

wa
wa
Removal (disconnect power plug)
• Check cable, no longer use defect cable protection
• Check cable, no longer use defect cable protection
• Check power supply, power outlet, fuse
• Replace fuse
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Check cable, no longer use defect cable protection
• Manufacturer
service respectively must be called
• Manufacturer or responsible customer service
respectively must be called
• Manufacturer or responsible customer service
respectively must be called
• Arrange sharpening of knives
• Exchange knives
• Lubricating of knives
• Remove object
HHS 710/56
see last page
710 W
230 V~ / 50 Hz
1800 min
560 mm
510 mm
27 mm
a = <5.237 m/s²
vhw
a = <3.543 m/s²
vhw
K = 1.5 m/s²
99,8 dB (A) (according to regulation 2000/14/EC)
102 dB (A) (according to regulation 2000/14/EC)
80,4 dB (A); (according to regulation 2000/14/EG)
K = 3.0 dB (A)
2,4 m (2,8 m)
3,9 kg (4,9 kg)
II
or responsible
–1
customer
23