Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 258

Port Show Commands
-------------------------------------------------------------------------------
Unicast Packets
Multicast Packets
Broadcast Packets
Discards
Unknown Proto Discards
===============================================================================
===============================================================================
Ethernet-like Medium Statistics
===============================================================================
Alignment Errors :
FCS Errors
SQE Test Errors
CSE
Too long Frames
Symbol Errors
===============================================================================
*A:7210SAS>show#
Specific Port Output — The following table describes port output fields for a specific port.
Specific Port Output Fields
Description
Interface
Speed
Link-level
MTU
LoopBack Mode
Admin State
Oper State
Page 252
:
:
:
:
:
Label
A text description of the port.
The port ID displayed in the slot/mda/port format.
The speed of the interface.
Ethernet — The port is configured as Ethernet.
The size of the largest packet which can be sent/received on the Ether-
net physical interface, specified in octets.
Indicates if the port is in use by loopback mac-swap application. If
'None' is displayed the port is not enabled for loopback testing. If
'Internal' is displayed, the port is in use by port loopback mac-swap
application and no services can be configured on this port.
Up — The port is administratively up.
Down — The port is administratively down.
Up — The port is operationally up.
Down — The port is operationally down.
Additionally, the lag-id of the LAG it belongs to in addition to the
status of the LAG member (active or standby) is specified.
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide
0
0
0
0
0
0 Sngl Collisions :
0 Mult Collisions :
0 Late Collisions :
0 Excess Collisns :
0 Int MAC Tx Errs :
0 Int MAC Rx Errs :
Description
0
0
0
0
0
0
0
0
0
0