Interface QoS Commands
ingress
Syntax
ingress
Context
config>port>access
Description
This command enables the context to configure ingress buffer pool parameters which define the percentage
of the pool buffers that are used for CBS calculations and specify the slope policy that is configured in the
config>qos>slope-policy context.
pool
Syntax
[no] pool [name]
Context
config>port>access>egress
config>port>access>ingress
config>port>network>egress
config>port>network>ingress
config>port>access>uplink>egress
Description
This command configures pool policies.
On the MDA level, access and network egress and access ingress pools are only allocated on channelized
MDAs. On the MDA level, access and network egress and access ingress pools are only allocated on
channelized MDAs. Network ingress pools are allocated on the MDA level for non-channelized MDAs.
Note: The default pool cannot be modified, deleted or created.
Default
default
Parameters
name — Specifies the pool name, a string up to 32 characters long composed of printable, 7-bit ASCII
characters. If the string contains special characters (#, $, spaces, etc.), the entire string must be enclosed
within double quotes.
slope-policy
Syntax
slope-policy name
no slope-policy
Context
config>port>access>egress>pool
config>port>access>uplink>pool
config>port>network>egress
Description
This command specifies an existing slope policy which defines high and low priority RED slope parameters
and the time average factor. The policy is defined in the config>qos>slope-policy context.
Page 136
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide