802.1x Port Commands
dot1x
Syntax
dot1x
Context
config>port>ethernet
Description
This command enables access to the context to configure port-specific 802.1x authentication attributes. This
context can only be used when configuring a Fast Ethernet, gigabit or 10Gig EthernetFast Ethernet, gigabit
or 10Gig EthernetFast Ethernet or gigabit Ethernet LAN ports on an appropriate MDA.
keep-alive
Syntax
keep-alive timer
no keep-alive
Context
config>port>ethernet>dwl
Description
This command configures the time interval between keep-alive PDUs.
Default
no keep-alive
Parameters
timer — Specifies the time interval, in seconds, between keep-alive PDUs.
Values
retry-timeout
Syntax
retry-timeout timer
no retry-timeout
Context
config>port>ethernet>dwl
Description
This command configures the minimum wait time before re-enabling port after loop detection.
Default
no retry-timeout
Parameters
timer — Specifies the minimum wait time before re-enabling port after loop detection.
Values
Page 174
1 — 120
0, 10 — 160
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide