Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 210

Ethernet Ring Commands
A check is done for both the provisioning and test to ensure the MEP is an Y.1731 MEP (MEP provisioned
with domain format none, association format icc-based). If not, the operation fails. An error message in the
CLI and SNMP will indicate the problem.
test-pattern
Syntax test-pattern {all-zeros | all-ones} [crc-enable]
no test-pattern
Context config>eth-ring>path>eth-cfm>mep>eth-test-enable
Description
This command configures the test pattern for eth-test frames.
The no form of the command removes the values from the configuration.
Parameters all-zeros — Specifies to use all zeros in the test pattern.
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
Default
all-zeros
bit-error-threshold
Syntax bit-error-threshold bit-errors
Context config>eth-ring>path>eth-cfm>mep
Description
This command specifies the lowest priority defect that is allowed to generate a fault alarm.
Default 1
Parameters
bit-errors — Specifies the lowest priority defect.
Values
low-priority-defect
Syntax low-priority-defect {allDef | macRemErrXcon | remErrXcon | errXcon | xcon | noXcon}
Context config>eth-tunnel>path>eth-cfm>mep
Description
This command specifies the lowest priority defect that is allowed to generate a fault alarm.
Default remErrXcon
Values
Page 204
0 — 11840
allDef DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM,
and DefXconCCM
macRemErrXconOnly DefMACstatus, DefRemoteCCM, DefErrorCCM, and
DefXconCCM
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide