Lag Hashing Fields Used For 7210 Sas-R6; Table 11: Lag Hashing Mechanism For Services Configured On 7210 Sas-R6 Devices - Alcatel-Lucent 7210 SAS M Interface Configuration Manual

1. VPLS service, SDP to SDP: Test has been performed only for VC label variation with
2. In the LSR case, incoming labels are used for hashing.
3. 'Learnt' wherever mentioned corresponds to Destination MAC.
4. Source/Destination MAC refer to 'Customer Source/Destination MACs' unless otherwise

LAG Hashing Fields used for 7210 SAS-R6

Table 11: LAG Hashing mechanism for services configured on 7210 SAS-R6 devices

Services
VPLS service:
SAP to SAP
VPLS service:
SAP to SDP
7210 SAS M, T, X, R6, Mxp Interface Configuration Guide
the same Tunnel label.
specified.
Packet fields used for Hashing for differ-
IP traffic (Learnt) : Source and Destination
IP, Source and Destination L4 ports
PBB traffic (Learnt): BDA, BSA, VLAN
MPLS traffic (Learnt): Source and
Destination MAC (Outer MACs of the
Ethernet packet that encapsulates MPLS
packet), VLAN
Non-IP traffic (Learnt): Source and
Destination MAC, EtherType, VLAN
IP traffic (learnt and unlearnt ): Source and
Destination IP, Source and Destination L4
ports, Ingress Port-Id
PBB traffic : BDA, BSA, ISID, Ingress Port-
Id
MPLS traffic: Source and Destination IP,
MPLS label stack (Two labels deep), Ingress
Port-Id.
Non-IP traffic (learnt and unlearnt): Source
and Destination MAC, EtherType, VLAN,
Ingress Port-Id.
ent traffic types
Interface Configuration
Page 61