Danfoss VLT AQUA Drive FC 202 Operating Instructions Manual page 44

5. Electrical installation
5.1.29. Switches S201, S202, and S801
Switches S201 (Al 53) and S202 (Al 54) are used to select a current (0-20
mA) or a voltage (0 to 10 V) configuration of the analog input terminals
53 and 54 respectively.
Switch S801 (BUS TER.) can be used to enable termination on the RS-485
port (terminals 68 and 69).
Please note that the switches may be covered by an option, if fitted.
Default setting:
S201 (AI 53) = OFF (voltage input)
5
S202 (AI 54) = OFF (voltage input)
S801 (Bus termination) = OFF
44
Illustration 5.55: Switches location.
®
MG.20.M5.02 - VLT is a registered Danfoss trademark
®
VLT AQUA Drive
Operating Instructions