Danfoss VLT AQUA Drive FC 202 Operating Instructions Manual page 43

®
VLT AQUA Drive
Operating Instructions
Illustration 5.50:
Step 5: By pressing the [Hand on] button, the LED above the button
should be lit and the motor may rotate.
Illustration 5.51:
Step 6: The speed of the motor can be seen in the LCP. It can be
▲
adjusted by pushing the up and down
Illustration 5.52:
▼
arrow buttons.
®
MG.20.M5.02 - VLT is a registered Danfoss trademark
Step 7: To move the cursor, use the left ◄ and right ► arrow buttons.
This enables changing the speed in larger increments.
Illustration 5.53:
Step 8: Press the [Off] button to stop the motor again.
Illustration 5.54:
Step 9: Change two motor wires if the desired rotation of direction is
not achieved.
Remove mains power from the frequency converter
before changing motor wires.
5. Electrical installation
5
43