Replace The Diesel Fuel Filter/Water Separator Element - Diesel Models - Genie Z-34/22IC Service Manual

Table of Contents

Advertisement

July 2007
REV A
4 At the platform controls pull out the red
Emergency Stop button to the on position.
Result: The flashing beacon should be on
and flashing.
5 Press down the foot switch. Move the primary
boom switch to the down position, hold for a
moment and then release it. Move the
secondary boom switch to the down position,
hold for a moment and then release it.
Result: The descent alarm should sound when
each control switch is held down.
6 Press down the foot switch. Move the drive
control handle off center, hold for a moment
and then release it. Move the drive control
handle off center in the opposite direction, hold
for a moment and then release it.
Result: The travel alarm should sound when the
drive control handle is moved off center in
either direction.
Part No. 128267
Section 3 • Scheduled Maintenance Procedures
B-20
Replace the Diesel Fuel Filter/
Water Separator Element -
Diesel Models
Note: Engine specifications require that this
procedure be performed every 400 hours.
Replacing the diesel fuel filter is essential to good
engine performance and service life. A dirty or
clogged filter may cause the engine to perform
poorly and continued use may cause component
damage. Extremely dirty conditions may require
that the filter be replaced more often.
Note: Perform this procedure with the engine off.
1 Locate the fuel filter/water separator and loosen
the vent plug located on the fuel filter/water
separator head.
Z-34/22 IC
CHECKLIST B PROCEDURES
Explosion and fire hazard. Engine
fuels are combustible. Replace the
fuel filter in an open, well-
ventilated area away from heater,
sparks, flames and lighted
tobacco. Always have an
approved fire extinguisher within
easy reach.
3 - 31

Advertisement

Table of Contents
loading

Table of Contents