Seat LEON Owner's Manual page 79

Menu Function
Approximate distance in km that can
still be travelled with the fuel remain-
Operating ing in the tank, assuming the same
a) style of driving is maintained. This is
range
calculated using the current fuel con-
sumption.
This indicates the hours (h) and mi-
Journey dura-
nutes (min) since the ignition was
tion
switched on.
Distance covered in km (m) after
Distance cov-
switching on the ignition.
ered
Whenever you refuel the quality of the
natural gas is automatically verified
and is displayed when the ignition is
switched on. The display is made in a
CNG quality
percentage of between 70% and
100%. The greater the percentage dis-
played the lower the consumption may
be.
The average speed will be shown after
a distance of about 100 metres has
been travelled. Otherwise horizontal
Average speed
lines are displayed. The value shown is
updated approximately every 5 sec-
onds.
Digital display Current speed displayed in digital for-
of speed mat.
Speed warn-
If the stored speed is exceeded (be-
ing at --- km/h
tween 30 - 250 km/h, or 19 -
or Speed
155 mph), an audible warning is given
warning at ---
together with a visual warning.
mph
Driver information system
Menu Function
Oil tempera- Updated engine oil temperature digital
ture display
Coolant tem-
Digital display of the current tempera-
perature
ture of the liquid coolant.
gauge
a)
In vehicles with a natural gas engine, range and average con-
sumption refer only to data or natural gas consumption. If you
are in "petrol mode", the information of both data only appears
on the dash panel and not on the multifunction screen.
Storing a speed for the speed warning
● Select the display Speed warning at --- km/h
(--- mph)
● Press the button on the windscreen

wiper lever or the button on the multifunc-

tion steering wheel to store the current speed
and activate the warning.
If necessary, adjust the desired speed with-
●
in 5 seconds using the rocker switch
the windscreen wiper lever or by turning the
thumbwheel on the multifunction steering
wheel. Next, press the button

again or wait several seconds. The speed is
stored and the warning activated.
● To deactivate it press the button
the button . The stored speed is deleted.

Engine oil temperature display
Vehicles without multifunction steering
wheel
To view the temperature, press the rocker
–
›››
button Fig. 87
comes up. Enter into Journey data . With the
button move to the oil temperature
2
gauge.
Vehicles with multifunction steering wheel
To display the engine oil temperature, enter
–
the submenu Journey data and turn the
thumbwheel until the oil temperature dis-
play appears.
The engine reaches its operating temperature
when in normal driving conditions, the oil
temperature is between 80°C (180°F) and
120°C (250°F) . If the engine is required to
work hard and the outside temperature is
on

high, the engine oil temperature can in-
crease. This does not present any problems
as long as the warning lamps
or

ble on page 23 or 
do not appear on the display.
or

Additional electrical appliances
3 Not available in vehicles equipped with natural
gas engine (CNG).
Operation with the windscreen wiper lev-
–
er*: Press the rocker switch
until the main menu
2
›››

ta-

›››

table on page 23
»
›››
Fig. 87
2
77