Removing the net partition
Fold the rear seat backrests forward.
●
●
Press the left or right release catch
›››
Fig. 125
in the direction of the arrow
●
Remove the casing from the support in the
›››
direction of the arrow
Fig. 125
Fitting the net partition
Fold the rear seat backrests forward.
●
●
Fit the casing in the right and left supports.
Press the casing into the left and right sup-
●
ports in the opposite direction to the arrow
›››
Fig. 125
until it engages.
2
The red markings on the release buttons
should no longer be visible.
WARNING
Always secure objects, even when the net
●
partition is properly assembled.
There should be nobody behind the assem-
●
bled partition when the vehicle is moving.
CAUTION
Incorrect handling of the net partition could
cause damage.
●
Do not "release" the net partition when
lowering it, as the net and other vehicle parts
could be damaged. Roll down the net parti-
tion by hand.
Transport and practical equipment
Use of the net partition with the rear
seat backrests lowered
3 Applies to the model: LEON ST
.
1
.
2
Fig. 126
Assembling the net partition in the
rear seat backrests.
In the luggage compartment: net
Fig. 127
partition hooked into the rear seat backrests.
Fitting the net partition
●
Fold the rear seat backrests forward.
●
Remove the net partition from the side sup-
ports.
●
Place the net casing in the rail slots in the
›››
Fig. 126
direction of the arrows
●
Push the casing towards the left side of the
vehicle in the direction of arrow
and as far as it will go.
2
●
Check that the net is secure.
Pulling out and securing the net partition
›››
Pull up handle
Fig. 127
●
2
›››
net from the casing
Fig. 127
Hook in the net partition on the right side
●
›››
Fig. 127
(magnified image).
3
●
Hook in the net partition in the left side
›››
housing
Fig. 127
pulling the rod.
1
The net partition is properly assembled when
the T-shaped ends are firmly secured in the
›››
Fig. 127
corresponding housings
.
1
Retracting the net partition
●
Remove the rod from the housings in the
trims of the roof side members.
●
Roll up the net into the casing
lowering it with your hand.
4
.
1
›››
Fig. 126
to remove the
.
4
and
3
›››
Fig. 127
»
117