Seat LEON Owner's Manual page 70

● Time.
Navigation instructions.
●
● Outside temperature.
Compass.
●
›››
● Shift lever position
Recommended gear (manual gearbox)
●
›››
page 74.
Multifunction display (MFD) and menus
●
with different setting options
Service interval display
●
● Second speed display
Speed warning function
●
● Start-Stop system status display
›››
page 148.
● Low consumption driving status (ECO)
›››
page 69
● Identifying letters on engine (MKB).
● Active cylinder management display
›››
®
(ACT )* page 142
Mileage
The odometer registers the total distance
travelled by the car.
The odometer ( trip ) shows the distance trav-
elled since the last odometer reset. The last
digit of the trip recorder indicates distances
of 100 metres or one tenths of a mile.
● Briefly press the button
set the trip recorder to 0.
68
● Keep the button
seconds and the previous value will be dis-
played.
Time
page 133.
● To set the time, keep the button
pressed for more than 3 seconds to select
4
the hour or minute display.
To continue setting the time, press the up-
●
›››
per or lower part of the button
page 72.
ton down to scroll through the numbers
›››
page 80.
quickly.
›››
page 72.
● Press the button
›››
page 79.
setting the time.
The time can also be set via the
Setup
system
Compass
With the ignition on and the navigation sys-
tem on, the cardinal point corresponding to
the direction of travel of the vehicle is dis-
played on the instrument panel.
Selector lever position
The selected gear is displayed on the side of
the selector lever and on the instrument pan-
el display. In positions D and S, and with the
Tiptronic, the corresponding gear is also dis-
played.
›››
Fig. 82 to re-
4
Operation
pressed for about 3
4
›››
Fig. 82
. Hold but-
4
again in order to finish
4
key and

function button in the Easy Connect
›››
page 81.
Recommended gear (manual gearbox)
The recommended gear in order to save fuel
is displayed on the instrument panel while
›››
page 74.
you are driving
Second speed display (mph or km/h)
In addition to the speedometer, the speed
can also be displayed in a different unit of
measurement (in miles or in km per hour).
This option cannot be deactivated in models
destined for countries in which the second
speed must always be visible.
The second speed display can be adjusted in
the Easy Connect system via the
›››
page
the function button
Setup
Speed warning
When the speed setting is exceeded, this will
be indicated on the instrument panel display.
This is very useful, for example when using
winter tyres that are not designed for driving
at the maximum speed of the vehicle
›››
page 79.
The speed warning settings can be adjusted
in the Easy Connect system via the
›››
and the function button
Setup
Start-Stop operating display.
Updated information relating to the status is
displayed on the instrument panel
›››
page 148.
key and

81.
key

page 81.